SNR S2940-8G-v2 Switch Configuration Guide
Port Configuration
Chapter 3
Port Configuration
3.1 Introduction to Port
Switch contains Cable ports and Combo ports. The Combo ports can be configured to as either
1000GX-TX ports or SFP Gigabit fiber ports.
If the user needs to configure some network ports, he/she can use the interface ethernet
<interface-list> command to enter the appropriate Ethernet port configuration mode, where <interface-
list> stands for one or more ports. If <interface-list> contains multiple ports, special characters
such as ';' or '-' can be used to separate ports, ';' is used for discrete port numbers and '-' is used
for consecutive port numbers. Suppose an operation should be performed on ports 2,3,4,5 the
command would look like: interface ethernet 1/2-5. Port speed, duplex mode and traffic con-
trol can be configured under Ethernet Port Mode causing the performance of the corresponding
network ports to change accordingly.
3.2 Network Port Configuration Task List
1. Enter the network port configuration mode
2. Configure the properties for the network ports
(a) Configure combo mode for combo ports
(b) Enable/Disable ports
(c) Configure port names
(d) Configure port cable types
(e) Configure port speed and duplex mode
(f) Configure bandwidth control
(g) Configure traffic control
(h) Enable/Disable port loopback function
(i) Configure broadcast storm control function for the switch
(j) Configure scan port mode
(k) Configure rate-violation control of the port
47
To Next Page
Loading...
General