SNR S2940-8G-v2 Switch Configuration Guide
Switch management
PC application such as Hyperterminal or PuTTY - makes communication between the switch and
your PC or terminal possible.
1. Start the terminal-emulation program and open a session if you are using a PC or terminal.
2. Start a terminal-emulation session.
3. Configure the baud rate and character format of the PC or terminal to match the console port
default characteristics:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
Step 3: Entering switch CLI interface
Power on the switch, the following appears in the terminal-emulation window, that is the CLI
configuration mode for Switch.
System is booting, please wait...
Testing RAM...
0x04000000 RAM OK.
Attaching to file system ... done.
Loading flash:/nos.img ...
Starting at 0x10000...
Attaching to file system ... done.
Current time is Sun Jan 01 00:00:00 2006
SNR-S2980G-24T Series Switch Operating System
Software Version 6.2.138.30
Compiled Sep 14 17:45:37 2011
Loading factory config ...
Switch>
The user can now enter commands to manage the switch. For a detailed description for the
commands, please refer to the following chapters.
13
To Next Page
Loading...
General