SNR S2940-8G-v2 Switch Configuration Guide
DHCPv6 Configuration
1. To enable/disable DHCPv6 service
Command Explanation
Global Mode
service dhcpv6
no service dhcpv6
To enable DHCPv6 service.
2. To configure DHCPv6 address pool
(a) To achieve/delete DHCPv6 address pool
Command Explanation
Global Mode
ipv6
dhcp
pool
<poolname>
no
ipv6
dhcp
pool
<poolname>
To configure DHCPv6 address pool.
(b)To configure parameter of DHCPv6 address pool
Command Explanation
DHCPv6 address pool Configuration Mode
network-address <ipv6-pool-
start-address> { <ipv6-pool-
end-address>
|
<prefix-length>
}
[eui-64]
no network-address
To configure the range of IPv6 address assignable of ad-
dress pool.
dns-server <ipv6-address>
no dns-server <ipv6-address>
To configure DNS server address for DHCPv6 client.
domain-name <domain-name>
no domain-name <domain-
name>
To configure DHCPv6 client domain name.
excluded-address <ipv6-
address>
no excluded-address <ipv6-
address>
To exclude IPv6 address which isn't used for dynamic as-
signment in address pool.
lifetime { <valid-time> | infinity } {
<preferred-time> | infinity }
no lifetime
To configure valid time or preferred time of DHCPv6 address
pool.
3. To enable DHCPv6 server function on port.
Command Explanation
Interface Configuration Mode
ipv6
dhcp
server
<poolname>
[preference <value>] [rapid-
commit] [allow-hint]
no
ipv6
dhcp
server
<poolname>
To enable DHCPv6 server function on specified port, and
binding the used DHCPv6 address pool.
229
To Next Page
Loading...
General