SNR S2940-8G-v2 User Manual

SNR S2940-8G-v2 Switch Configuration Guide
RADIUS Configuration
10.1.1.1
10.1.1.2
RADIUS Server
10.1.1.3
Figure 50.2: The Topology of IEEE802.1x configuration
Switch(config)#radius-server accounting host 10.1.1.3
Switch(config)#radius-server key test
Switch(config)#aaa enable
Switch(config)#aaa-accounting enable
50.3.2 IPv6 Radius Example
2004:1:2:3::1
2004:1:2:3::2
RADIUS Server
2004:1:2:3::3
Figure 50.3: The Topology of IPv6 Radius configuration
A computer connects to a switch, of which the IP address is 2004:1:2:3::2 and connected with
a RADIUS authentication server without Ethernet1/0/2; IP address of the server is 2004:1:2:3::3
and the authentication port is defaulted at 1812, accounting port is defaulted at 1813.
Configure steps as below:
Switch(config)#interface vlan 1
Switch(Config-if-vlan1)#ipv6 address 2004:1:2:3::2/64
Switch(Config-if-vlan1)#exit
Switch(config)#radius-server authentication host 2004:1:2:3::3
Switch(config)#radius-server accounting host 2004:1:2:3::3
Switch(config)#radius-server key test
Switch(config)#aaa enable
Switch(config)#aaa-accounting enable
342

SNR S2940-8G-v2 Specifications

General

Brand	SNR
Model	S2940-8G-v2
Category	Switch
Language	English