SNR S2940-8G-v2 Switch Configuration Guide
Basic Switch Configuration
Step 6:
The following is the configuration for the system update image file.
[Boot]: load nos.img
Using switch device
TFTP from server 192.168.1.66; our IP address is 192.168.1.2
Filename 'nos.img'.
Load address: 0x82000000
Loading: ###########
done
Bytes transferred = 51635 (c9b3 hex)
[Boot]:
Step 7:
Execute write nos.img in BootROM mode. The following saves the system update image file.
[Boot]: write nos.img
File exists, overwrite? (Y/N)[N] y
Writing flash:/nos.img..............................................
...............................................................
Write flash:/nos.img OK.
[Boot]:
Step 8:
After successful upgrade, execute run or reboot command in BootROM mode to return to CLI
configuration interface.
[Boot]: run (or reboot)
Other commands in BootROM mode
1. DIR command
Used to list existing files in the FLASH.
[Boot]: dir
5399893 nos.img
1 file(s), 0 dir(s)
Total size:6995456 bytes , used size:5422080 bytes, free size:1573376 bytes
[Boot]:
2. boot command
Used to set the IMAGE file to run upon system start-up, and the configuration file to run upon
configuration recovery.
37
To Next Page
Loading...
General