Solo MINI - WRITE Commands for Configuration

SOLO Communication Manual - UART and USB
www.solomotorcontrollers.com
September 2021 - Revision V_1.0.1 Copyright © 2021, All right Reversed. SOLO motor controllers.
19
WRITE Commands:
Below all the existing Write commands to set a value in SOLO with their description for UART or
USB communication for are listed.
0x01 : Set Device Address
Code: 0x01
Set Device Address
Data Type
Data Range
Units
Memory Storage
Default Value
Uint32
[0-254]
N/A
M
0
Description:
This command sets the desired device address for a SOLO unit; the address can be used to
network multiple SOLO’s in a single network if the address assigned to each unit is unique.