SOLO Communication Manual - UART and USB
www.solomotorcontrollers.com
September 2021 - Revision V_1.0.1 Copyright © 2021, All right Reversed. SOLO motor controllers.
62
UART/USB Packet Formation Examples:
Below, you can find a number of examples on how to form packets for different purposes for
sending to SOLO.
_ NOTE : The SPACE character in between the bytes below, is just for readability purposes and
ASCII code of SPACE shouldn’t be sent to SOLO, all the bytes should be sent to SOLO one after
another with nothing in between.
-NOTE: The device address in all the packets below is considered as “0”, since this is the default
device address. If you change the device address you must also change it alle in these packets as
well.
To Next Page
Loading...