5-37
4. Switch Check (2)
Page 2 Address 54 to 58
Using method:
1) Select page: 2, addresses: 54 to 58.
2) By discriminating the dispaly data, the pressed key can be
discriminated.
Address
Data
00 to 13 14 to 3A 3B to 63 64 to 90 91 to BC BD to E8 E9 to FF
54 VOLUME+ VOLUME –
(KEY AD0)
(PK-47/48 board) (PK-47/48 board)
(IC303 &•) (S705) (S707)
55
CONTROL DOWN
CONTROL UP DISPLAY BRIGHT+ BRIGHT–
(KEY AD1)
(PK-47/48 board) (PK-47/48 board) (PK-47/48 board) (PK-47/48 board) (PK-47/48 board)
(IC303 &ª) (S701) (S701) (S704) (S711) (S712)
56
CONTROL RIGHT CONTROL LEFT
CONTROL SET FLASH
LCD BACKLIGHT LCD BACKLIGHT
(KEY AD2)
(PK-47/48 board) (PK-47/48 board) (PK-47/48 board) (PK-47/48 board) OFF ON
(IC303 *º) (S701) (S701) (S701) (S708)
(PK-47/48 board) (PK-47/48 board)
(S713) (S713)
57
PICTURE EFFECT
PROGRAM AE
(KEY AD3)
(PK-47/48 board) (PK-47/48 board)
(IC303 *¡) (S703) (S709)
58 FOCUS
FOCUS AUTO
(KEY AD4) MANUAL
(MF UNIT)
(IC303 *™) (MF UNIT)
5. Self Diagnosis Code
5-37 E
Display Code
C:32:01
C:13:01
E:91:01
*1
*1
Countermeasure
Change the disk and turn off the main
power then back on.
Replace the floppy disk.
Format the floppy disk with the MVC-
FD83/FD88.
Cause
Defective floppy disk.
• The type of floppy disk that cannot be
used by this machine, is inserted.
(Such as 2DD)
• Data is damaged.
• Unformatted disk is inserted.
Abnormality when flash is being
charged.
Caution Display During Error
DRIVE ERROR
DISK ERROR
Flash LED
Flash display
Flashing at 3.2 Hz
—
Note : The error code is cleared if the battery is removed, except defective flash.
*1 : The error display is given in two ways.
*2 : When the flash charging failed, Page:D, Address:C7, Data:04 are written.
After repair, be sure to write Page:D, Address:C7, Data:00.
[Power supplying Method]
Use the AC power adaptor (BC-V615) when supplying the power to this set.
C:63:00
E:61:00
C:63:10
E:61:10
Repair by service engineers only.
When failed in the focus initialization.
When failed in the zoom initialization.
*2
To Next Page
Loading...
