Source fire Sourcefire 3D System - Page 190

Version 5.2 Sourcefire 3D System Installation Guide 190
Hardware Specifications
Sourcefire 8000 Series Devices
Chapter 6
Use the 10GBASE MMSR and SMLR NetMod Optical Parameters table to
understand the optical parameters of the fiber interfaces.
10GBASE MMSR and SMLR NetMod Optical Parameters
PARAMETER 10GBASE MMSR 10GBASE SMLR
Optical connectors LC duplex LC duplex
Bit rate 10.000Gbps 10.000Gbps
Baud rate/
encoding/tolerance
10.3125Gbps /
64/66b encoding /
+/- 100 ppm
10.3125Gbps /
64/166b encoding /
+/- 100 ppm
Optical interface Multimode Single mode only
Operating distance 840-860 nm
(850 nm typical)
26m (85 ft) to 33 m (108 ft) for 62.5 μm/125 μm fiber
(modal BW 160 to 200 respectively)
66 m (216 ft) to 82 m (269 ft) for 50 μm/125 μm fiber
(modal BW 400 to 500 respectively)
Distances to 300 m (980 ft) are available with higher
quality (OM3) fiber.
Minimum distances (all):
2 m (6ft)
1270-1355 nm
(1310 nm typical)
2 m to 10 km (6 ft to
6.2 miles) for
9 μm/125 μm fiber
Transmitter
wavelength
840-860 nm
(850 nm typical)
1270-1355 nm
(1310 nm typical)
Maximum average
launch power
-1 dBm -0.5 dBm
Minimum average
launch power
-7.3 dBm -8.2 dBm
Maximum average
power at receiver
-1 dBm -0.5 dBm
Receiver sensitivity -9.9 dBm -14.4 dBm