www.spacelabshealthcare.com
2-13
91390 QUBE
S ETUP
If multiple module housings are present, external devices must be
connected to the last module housing in the daisy-chain (the
housing electrically farthest from the monitor on the SDLC bus).
Even though multiple connectors can be available, only the SDLC
connector on the most distal module housing can be used for
connecting external devices. Do not use more than a single Flexport
connector, regardless of how many module housings are present
(refer to Figure 2-8, Figure 2-9, or Figure 2-10 depending on your
monitor option).
If you install multiple Flexport interfaces, they must be daisy-
chained using the T-cable supplied with those devices. Up to three
Flexport interfaces can be connected in this way (refer to Figure 2-
8, Figure 2-9, or Figure 2-10 depending on your monitor option).
Figure 2-8 qube option A connected to 90499 module housing and
Flexports
To Next Page
Loading...
