Still MX-X - Page 95

Regular care and maintenance 5
Maintenance schedule
At operating hours
1000 h 2000 h 3000 h 4000 h 5000 h
Carried out
6000 h 7000 h 8000 h 9000 h 10000 h


Drive unit: check the tightness of the screw connection to the chassis (ensure the
appropriate torque).
Traction motor bearings:
check for operating noise.
Traction motor bearings
: replace if necessary.
Chassis, bodywork and fi
ttings
Bearing points and joints: check and lubricate.
Doors, flaps and covers: check function.
Doors, flaps and cove
rs: check the mounting and condition.
All moving parts: lubricate with a suitable lubricant.
Overhead guard: visually check the welded seams; use a dye penetrant procedure if
you suspect there are cracks.
Overhead guard: visually check for damage and deformations.
Rail switch(es): check the function and condition.
Support screws in the chassis: check the setting according to the specifications on
the nameplate. Adjust as necessary.
Battery compartment door and battery compartment hood: check and adjust as
necessary.
Battery compartment door and battery compartment hood: check and adjust as
necessary.
Battery compartment: check that the battery is securely positioned and check side
stops on the battery.
Chassis frame
Drive wheel: check the condition and check for wear and any foreign objects.
Drive wheel, wheel nuts or wheel screws and binding: check for secure attachment.
Load wheels: check the condition and mounting and check for wear and foreign
objects.
Load wheels: check for ease of movement.
Antistatic belt: check the condition.
St
eering system
S
teering: function check outside the aisle.
S
teering: check the steering angle (>90° on both sides).
Steering: check straight line travel.
Steering gears: lubricate with all-purpose grease.
523
1 804 2502 EN - 11/2017 89