LUCAS
®
3 Chest Compression System – Service Manual
3328798-002, ©2017 Physio-Control, Inc.
Page 16 of 91
3. Start the LUCAS 3 Program Loader software by executing LUCAS3_V3_X_REV_X_Service.exe file,
.
(Note. Different software versions can occur)
4. Click Init BT to connect PC to LUCAS 3 device via Bluetooth, and Wait for Program Loader to search for
LUCAS 3 device…
5. If No Devices Found message displayed, click Init BT and try again. Note: It may take up to 30 seconds for
the LUCAS 3 communication app to boot up. You may have to click Init BT 2 ~ 3 times before LUCAS device
shows up on the screen. If “BT Error” occurred repeatedly, refer to Bluetooth Connection Error
in
troubleshooting chapter.
6. When Program Loader found LUCAS 3, select the LUCAS that shall be connected.
7. When Bluetooth connection is established, the Program Loader screen will show CPUs information shown as
following pictures.
To Next Page
Loading...
