Summa S 75 - Page 8

S CLASS™ cutter User’s Manual
Table of contents IV
5 Maintenance and Cleaning ...................................................................5-1
5.1 Introduction..................................................................................................5-1
5.1.1 Cleaning the drive system..........................................................................5-1
5.1.2 Cleaning the media sensors ......................................................................5-2
5.1.3 Cleaning the Y-Guide Rail .........................................................................5-3
5.1.4 Cleaning the nose piece (tangential machine only)..................................5-3
5.1.5 Cleaning the OPOS system.......................................................................5-4
5.1.6 Changing the fuse ......................................................................................5-5
6 Specs and general information............................................................6-1
6.1 Introduction..................................................................................................6-1
6.1.1 Product features .........................................................................................6-1
6.2 Specifications ..............................................................................................6-3
6.2.1 Cutter ..........................................................................................................6-3
6.2.2 Media ..........................................................................................................6-3
6.2.3 Knife, pen and pouncing tool .....................................................................6-4
6.2.4 Interface......................................................................................................6-5
6.2.5 Firmware.....................................................................................................6-5
6.2.6 Performance ...............................................................................................6-6
6.2.7 Certifications...............................................................................................6-6
6.2.8 Environmental.............................................................................................6-7
6.2.9 Electrical .....................................................................................................6-7