SWDE200B Operation & Maintenance Manual
engine is running.
Check some parts at regular intervals. Repair or replace, if necessary. (Refer to the chapter
“maintenance” of this manual)
Make sure all parts are in good condition and fit correctly. Replace worn or damaged
parts. Clean any excess lubricant.
When adjusting electric system or welding on machine, disconnect negative pole (一) of battery.
1.18 SUPPORTING MACHINE CORRECTLY
Prohibit repairing or maintaining machine
before the machine is well supported.
Before maintenance, lower the drilling tools to
the ground or lower the drilling mast on the
bracket.
Don’t support the machine on any slag, hollow
brick, or fragile objects.
1.19 TRASH CLEANING
Keep the engine, radiator, battery, hydraulic
line, fuel tank, and cabin clean.
After stopping the engine, the engine
temperature may rise immediately. Open
engine compartment doors to cool engine as
soon as possible and clean engine apartment.
Clean machine at regular intervals, eliminate
excess lubricant and other trash. Do not spray
water or vapor into cabin.
1.20 PREVENTING BATTERY EXPLOSION
Prohibit fire or flame close to the battery top,
To Next Page
Loading...