SUNWARD SWDE200B - Working Timer Maintenance Schedule; Pre-Maintenance Preparations; Fuel and Lubrication Oil Usage

SWDE200B Operation & Maintenance Manual
65
If there is any question on the machine, please repair before operating, or contact with your
delegated local distributor.
Please do all the maintenance recommended in the manual book. (see overleaf)
7.1.3 Often Check Working Timer
 Decide when to do maintenance according to
the working hour.
 The maintenance interval term is based on
normal operating condition. If operating in
scurvy condition, shorten the term to do
maintenance.
7.1.4 Preparation before Maintenance
 Park the machine on flat ground
 Level the drilling frame.
 Run the engine idle at low rev for 5 minutes.
 Shut off the engine, take off the key from
switch. (If it is required to do maintenance
during running of engine, make sure there is
person in cab.
 Place the pilot controlled cutting rob to lock position.
 Please hang a brand read “NO OPERATION” on the left joystick before maintenance.
7.1.5 Correct Use of Fuel and Lubrication Oil
【IMPORTANT】
Always use the recommended fuel and lubrication oil.
Otherwise, it would result in damage to the machine and loss in warranty right.