SWDE200B Operation & Maintenance Manual
hydraulic oil and lubricant:
Inspect clamps and ensure they are intact, check hoses and pipes to see they are in the right
position; check hydraulic oil cooler, connections; check leakage using a piece of cardboard;
never check leakage by hand. prevent pressure oil pierce skin and result in injured.
Tighten, repair, or replace any clamps, pipes, hose, oil cooler, and flange bolts of oil cooler.
Do not twist or punch any high-pressured pipe.
Do not use any twisted or damaged pipe or hose.
Inspect short circuits. Short circuiting of the electric system can cause fire.
Check cables and wires before every shift or after 8 hours operation.
Check connectors before every shift or after 8 hours operation.
Tighten, repair, or replace any loosened or damaged cables, wires and connectors before
operation. Do not operate the machine if the cables and wires are not in good condition.
Repair switch.
Check key switch and engine emergency stop switch before everyday operation. Repair
immediately if they are not functioning.
Fire might be even worse or GBH might happen if engine cannot be stopped in case
Clean out flammable materials.
Spilled fuel, excessive coal dust, and other flammable materials may cause fire. Keep the
machine clean every day to prevent fire.
To Next Page
Loading...