Sur-Gard System Five - Page 84

6.0 Options
- 84 -
Option [609]: UPS AC 1 Trouble
Default (Disabled)
This option is used to enable or disable UPS AC 1 input supervision. If this option is set to ‘Disabled’, the trouble condition is not reported.
NOTE: Must be enabled for UL installations.
Option [610]: UPS AC 2 Trouble
Default (Disabled)
This option is used to enable or disable UPS AC 2 input supervision. If this option is set to ‘Disabled’, the trouble condition is not reported.
NOTE: Must be enabled for UL installations.
Option [611]: UPS Battery 1 Trouble
Default (Disabled)
This option is used to enable or disable UPS Battery 1 input supervision. If this option is set to ‘Disabled’, the trouble condition is not reported.
NOTE: Must be enabled for UL installations.
Option [612]: UPS Battery 2 Trouble
Default (Disabled)
This option is used to enable or disable UPS Battery 2 input supervision. If this option is set to ‘Disabled’, the trouble condition is not reported.
NOTE: Must be enabled for UL installations.
Option [613]: SG-Serial Automation Pri - 1 Trouble
Default (Enabled)
This option is used to enable or disable SG-Serial Automation 1 supervision for the primary SG-CPM5. If this option is set to ‘Disabled’, the trouble
condition is not reported.
NOTE: Must be enabled for UL installations.
Option [615]: SG-Serial Automation Sec - 1 Trouble
Default (Disabled)
Secondary SG-CPM5 Default (Enabled)
This option is used to enable or disable SG-Serial Automation 1 supervision for the secondary SG-CPM5. If this option is set to ‘Disabled’, the trouble
condition is not reported.
NOTE: Must be enabled for UL installations.
Option [617]: SG-Serial CPM1 Printer 1 Trouble
Default (Enabled)
This option is used to enable or disable SG-CPM5 1 printer supervision. If this option is set to ‘Disabled’, the trouble condition is not reported.
Option [618]: SG-Serial CPM2 Printer 1 Trouble
Default (Enabled)
This option is used to enable or disable SG-CPM5 2 printer supervision. If this option is set to ‘Disabled’, the trouble condition is not reported.
Option [621]:SG-TCP Automation Pri - 1 Trouble
Default (Enabled)
This option is used to enable or disable SG-TCP automation port (port 1025) supervision for the primary SG-CPM5. If any of these options are set to
‘Disabled’, the corresponding trouble condition is not be reported.
Option [622]: SG-TCP Automation Pri – 2 Trouble
Default (Disabled)
This option is used to enable or disable the supervision for the SG-TCP Automation Port #2 for the Primary CPM5. If this option is set to ‘Disabled’,
the trouble condition is not reported.