6.0 Options
- 85 -
Option [623]: SG-TCP Automation Pri – 3 Trouble
Default (Disabled)
This option is used to enable or disable the supervision for the SG-TCP Automation Port #3 for the Primary CPM5. If this option is set to ‘Disabled’,
the trouble condition is not reported.
Option [624]: SG-TCP Automation Pri – 4 Trouble
Default (Disabled)
This option is used to enable or disable the supervision for the SG-TCP Automation Port #4 for the Primary CPM5. If this option is set to ‘Disabled’,
the trouble condition is not reported.
Option [631]:SG-TCP Automation Sec - 1 Trouble
Default (Disabled)
Secondary SG-CPM5 Default (Enabled)
This option is used to enable or disable the SG-TCP automation port (port 1025) supervision for the secondary SG-CPM5. If this option is set to ‘Dis-
abled’, the trouble condition is not reported.
Option [632]: SG-TCP Automation Sec – 2 Trouble
Default (Disabled)
This option is used to enable or disable the supervision for the SG-TCP Automation Port #2 for the Secondary CPM5. If this option is set to ‘Dis-
abled’, the trouble condition is not reported.
Option [633]: SG-TCP Automation Sec – 3 Trouble
Default (Disabled)
This option is used to enable or disable the supervision for the SG-TCP Automation Port #3 for the Secondary CPM5. If this option is set to ‘Dis-
abled’, the trouble condition is not reported.
Option [634]: SG-TCP Automation Sec – 4 Trouble
Default (Disabled)
This option is used to enable or disable the supervision for the SG-TCP Automation Port #4 for the Secondary CPM5. If this option is set to ‘Dis-
abled’, the trouble condition is not reported.
Option [665]:TCP Printer Pri - 1 Trouble
Default (Enabled)
This option is used to enable or disable TCP Printer 1 (port 1027) supervision for the primary SG-CPM5. If this option is set to ‘Disabled’, the trouble
condition is not reported.
Option [675]:TCP Printer Sec - 1 Trouble
Default (Enabled)
This option is used to enable or disable TCP Printer 1 (port 1027) supervision for the secondary SG-CPM5. If this option is set to ‘Disabled’, the
trouble condition is not reported.
Option [709]:SG-TCP/IP CPM1 Visual Verification Trouble
Default (Enabled)
This option is used to enable or disable visual verification port (port 2025) supervision for the primary SG-CPM5. If this option is set to ‘Disabled’, the
trouble condition is not reported.
Option [710]:SG-TCP/IP CPM2 Visual Verification Trouble
Default (Enabled)
This option is used to enable or disable visual verification port (port 2025) supervision for the secondary SG-CPM5. If this option is set to ‘Disabled’,
the trouble condition is not reported.
To Next Page
Loading...
