Suunto Ocean - Calibrating Foot Pod; Calibrating Power Pod; Flashlight; Alarms

3.13.2. Calibrating foot pod
When you pair a foot pod, your watch automatically calibrates the pod using GPS. We
recommend using the automatic calibration, but you can disable it if needed from the pod
settings under Connectivity » Paired devices.
For the
first calibration with GPS, you should select a sport mode where the foot pod is used
and the GPS accuracy is set to Best. Start the recording and run at a steady pace on a level
surface, if possible, for at least 15 minutes.
Run at your normal average pace for the initial calibration, and then stop the exercise
recording. The next time you use the foot pod, the calibration is ready.
Your watch automatically re-calibrates the foot pod as needed whenever GPS speed is
available.
3.13.3. Calibrating power pod
For power pods (power meters), you need to initiate the calibration from the sport mode
options in your watch.
To calibrate a power pod:
1. Pair a power pod with your watch if you have not done so already.
2. Select a sport mode that uses a power pod and then open the mode options.
3. Select Calibrate power POD and follow the instructions in the watch.
You should re-calibrate the power pod from time to time.
3.14. Flashlight
Your Suunto Ocean has an extra bright backlight that you can use as a flashlight.
To activate the flashlight, swipe up from watch face or press the lower button and select
Control panel. Scroll to Flashlight and turn it on by tapping on it or by pressing the middle
button.
To turn
o the flashlight, press the middle button or swipe right.
3.15. Alarms
In the Alarms menu of your watch, under Settings you can set dierent adaptive alarm types.
You can set an alarm for sunrise and sunset and also for storm alarm.
For dive alarm settings, see 5.4. Dive alarms and 6.4. Freedive alarms.
3.15.1. Sunrise and sunset alarms
The sunrise/sunset alarms in your Suunto Ocean are adaptive alarms based on your location.
Instead of setting a
fixed time, you set the alarm for how much in advance you want to be
alerted before the actual sunrise or sunset.
The sunrise and sunset times are determined via GPS, so your watch relies on the GPS data
from the last time you used GPS.
To set sunset/sunrise alarms:
1. From watch face, long press the middle button and scroll down to and select Alarms.
2. Scroll to the alarm that you want to set and select by pressing the middle button.
Suunto Ocean
18