1. Decompression information
2. Ascent speed with color coding
3. Dive time
4. Depth
5. Switch window with changeable information
6. Arch illustrating key information: no deco limit, tank pressure, time to surface, stop time
5.2.6. Key information during diving
During diving, your watch displays the following information:
Decompression information:
The decompression area on the screen is fixed and shows the following data in the following
situations:
Surface time: When surfacing, the decompression area is replaced with a surface timer. It
shows the elapsed time between surfacing from a dive and beginning a descent for the
subsequent dive. It shows the time in minutes and seconds up to one hour. Above one hour,
the time is displayed in hours and minutes up to 24 hours, and after that, hours up to seven
days and then only in days.
No Decompression Limit (NDL): Once a dive has started, the surface timer is replaced with
the NDL time. It shows the time remaining in minutes at the current depth until mandatory
decompression stops are required. If NDL time is above 99 minutes, it is displayed as >99.
When the NDL time is 5 minutes or less, a mandatory alarm is triggered and the display area
is highlighted until resolved or replaced with decompression information. Read more about
the mandatory alarms in 5.4.1. Mandatory dive alarms.
Suunto Ocean
42
To Next Page
Loading...
