To track your underwater route while diving, you need to enable both the GPS and the Dive
route settings. The dive route is not visible in your dive computer. It will be synced to your
dive log in Suunto app when connected to your mobile phone.
Note that the dive route signal can be compromised in the following situations: overhead
environments like caves or wrecks, indoor pools or with poor on nonexistent GPS signal.
NOTE: To track your dive route, you need to start your dive from the pre-dive screen and
ensure your GPS signal is green. See 5.2.4. Pre-dive screen and dive options.
NOTE: Syncing your dive route to Suunto app might take some time due to the large
amount of data.
Dive start depth
Sets the depth threshold for starting and ending a dive. The default depth is 1.2 m (4 ft) and
the maximum is 3.0 m (9.8 ft).
Dive end time
Once you are shallower than the set start depth for the dive, Suunto Ocean will start
calculating the elapsed time at the surface. You can set your desired time under Dive end
time. Once this time has elapsed, your dive ends automatically. If you continue diving before
the set end time, the dive continues. You can define the time between 1 and 10 min. The
default setting is 5 min.
TIP: Adjust the end time to longer if you are, for example, an instructor and need to
communicate at the surface within the dive. Adjust it to shorter to see the dive summary more
quickly.
Suunto Ocean
48
To Next Page
Loading...
