Group Calls: Control over Permission to Speak (Operator) 81 FlexSet 120/280 User Guide
Display Message Key LED
Group Calls: Control over Permission to Speak (Operator)
This function is relevant for Group Calls defined to admit participants only in
mute mode. This feature allows the Group Operator to grant a participant
permission to speak - either by operator's own initiative or as a response to the
Request to Speak sent by a Group Call participant. The operator can ignore the
Request to Speak, or act as described below. To utilize the feature, the Group
Operator's FlexSet must be equipped with a display and the DSS buttons
programmed with participants' dial numbers.
To respond to the Request to Speak:
1. Listen for the muted ring and check the station number/name displayed. ANSWER
conf
#
REQ SPEAK
yyyy
WINKING
(fast flashing)
2. Press the winking DSS button associated with the station that is requesting ANSWER
conf
#
TRX. OFF
yyyy
FLASHING
permission to speak.
3. Notify the participant that permission to speak is given.
ANSWER CONF#
FLASHING
To initiate permission to speak:
1. Press the steadily lit DSS button associated with the required participant. ANSWER CONF#
TRX. ON
yyyy
FLASHING
2. Ask the participant to start speaking.
To retract permission to speak:
1. Notify the participant that the permission will be retracted.
2. Press the flashing DSS button associated with the participant to be muted.
ANSWER CONF#
TRX. OFF
yyyy
STEADILY LIT
CAUTION !
A Group Operator who left the conference and rejoined in the mute
mode must give himself permission to speak by pressing the
steadily lit DSS button preprogrammed with his own dial number.
conf# = Conference Port dial number or name
x = Group Call Operator dial number or name
y = Station dial number or name
To Next Page
Loading...
