Individual Remote System Services (Freedom) - IRSS 93 FlexSet 120/280 User Guide
Display Message Key LED
Placing IRSS calls
• For IRSS calls placed from phones that send Caller ID, the IRSS feature must
be enabled at your Coral station. See steps below.
• For IRSS calls placed from phones that do not send Caller ID information,
the IRSS feature must be enabled using the Executive Privilege feature. See
page 94.
To place a call from IRSS phone providing Caller ID:
1. Place a call to your Coral station.
2. Listen for a distinctive dial tone.
3. Dial your 4 digit passcode (if required by Class of Service).
4. Listen for the dial tone.
5. Dial the required destination number.
Possible destinations can be: external number (stationary or cellular),
network number, or a Coral destination, including station, trunk/trunk group,
dial service, routing access, public/private library, or voice mail.
Note: If your destination is an external number, it should be preceded by
an external line access code.
• If your destination is voice mail (IVR access code), skip to page 98.
• If your destination is a FlexiCall All feature, skip to page 99.
• To enable another IRSS phone, skip to page 100.
6. Listen for the ringback tone.
7. Wait for an answer.
8. You can activate any of the options described in the table on page 95.
To Next Page
Loading...
