Individual Remote System Services (Freedom) - IRSS 94 FlexSet 120/280 User Guide
Display Message Key LED
To place a call from IRSS phone that does not provide Caller ID:
This applies for IRSS calls from off-site phones that do not possess a Caller ID
number and, therefore, cannot be identified by the Coral.
Notes:
1) Some telephones may be denied the Executive Privilege feature
(defined by Class Of Service).
2) In order to use Executive Privilege your station must be defined
with a passcode (see page 131).
1. Place a call to the Executive Privilege number (contact your system
administrator for that number).
2. Listen for the dial tone.
3. Dial your own Coral station number.
4. Dial your 4 digit passcode. Listen for the distinctive dial tone.
5. Dial the required destination number.
Possible destinations can be: external number (stationary or cellular),
network number, or a Coral destination, including station, trunk/trunk group,
dial service, routing access, public/private library, voice mail.
Note: If your destination is an external number, it should be preceded by
an external line access code.
• If your destination is voice mail (IVR access code), skip to page 98.
• If your destination is a FlexiCall All feature, skip to page 99.
• To enable another IRSS phone, skip to page 100.
6. Listen for the ringback tone.
7. Wait for an answer.
8. You can activate any of the options described in the table on page 95.
To Next Page
Loading...
