Overload protection electronic
Short circuit protection electronic
Type of protection IP
Protection class II
CE low voltage power
supply
Operating temperature – °C to + °C
Safety standard EN /
EN
EMV standard EN /B
Technology Switching
Switch frequency KHz
Dielectric resistance V/ min
MTBF (MIL HDBK) , h
Installing urinal infrared electronics for the U 1
urinal flusher, 6 V battery
Cut the bare-wall protection flush against the wall, and
remove it together with the polystyrene support.
Suciently flush out the pipe.
Observe the following:
When performing the pressure test, the inlet flow control of
the flush valve must be set to free-flow.
TECE flush plates – TECEplanus infrared electronics
-
Flush plates
To Next Page
Loading...
