Suciently flush out the pipe.
Observe the following:
When performing the pressure test, the inlet flow control of
the flush valve must be set to free-flow.
Before mounting the cartridge, ensure that the inlet flow
control is closed so that no water can leak out during
assembly. Close the shut-o using an Allen key. In the free-
flow setting (fig. ), the shut-o slot is parallel with the flush
valve housing and in the closed setting (fig. ), it is at right
angles to the housing.
Connect the transformer cable to the mains connection
adapter. Ensure correct polarity when making the connec-
tions.
Note the maximum number of connected electronics (= )
and the maximum length of the connection cable (= m).
Remove the bare-wall plug and unscrew the fastening
screws on the bare-wall protection.
Install the electric cartridge (do not let the tool come into
contact with it) and tighten the screws by hand.
-
Flush plates
To Next Page
Loading...
