Place the electronics in the installation box, seal and place
back in the cistern.
Insert the splash guard for the electronics with the actu-
ation motor. The activation hooks must fit correctly in the
drain valve's drawbar eyelets. Tighten the splash guard
clamping screws.
Finally, install the flush plate.
... Toilet module (dry-wall and brick-wall) without conduits
Connect the cable coming out of the transformer to the
mains connection adapter (ensure correct polarity – see
details in fig. ).
Guide the cable from the actuation motor and the power
supply through the opening on the bottom left of the
splash guard.
Then, insert the splash guard with the actuation motor. The
activation hooks must fit correctly in the drain valve's draw-
bar eyelets. Tighten the splash guard clamping screws.
TECE flush plates – TECEplanus electronics, remote release
-
Flush plates
To Next Page
Loading...
