5-98
Tool Number Position Contact Input Table:
DI
Tool Number
POS6 POS5 POS4 POS3 POS2 POS1
Tool Number 1 OFF OFF OFF OFF OFF OFF
Tool Number 2 OFF OFF OFF OFF OFF ON
: : : : : : :
Tool Number 11 OFF OFF ON OFF ON OFF
Tool Number 12 OFF OFF ON OFF ON ON
: : : : : : :
Tool Number 63 ON ON ON ON ON OFF
Tool Number 64 ON ON ON ON ON ON
OFF means the contact does not function (Open); ON means the contact functions (Closed).
Absolute Value Type Encoder built-in Position Memory can permanently memorize the position
information of each tool number. When start the machine after powered off, the Driver will
automatically output the (DO) status to the controller; the controller performs binary decoding on the
signal to obtain the current position of tool number, and does not need to perform the Return to Origin
operation. If the 64th tool will be used, the 7th point INP signal must be added with P1~P6 to conduct
Output Determination.
When in first tool position, the Digital Output Signals P1~P6 and INP Signal will all be output,
when the Digital Output Signals P1~P6 and INP Signal are not all output, indicates the tool number is
no longer in the range, and timing of tool number is not in the range:
1. First time use of the Tool Magazine Mode; the first time use of the Cutter Setup Return to Zero
operation, to be able to operate correctly.
2. In the Process the Servo Motor moves to the next tool number position.
Tool Magazine Control Tool Number Position Contact Output Table:
DO
Tool Number
P6 P5 P4 P3 P2 P1 INP
Not in the Range OFF OFF OFF OFF OFF OFF OFF
Tool Number 1 ON ON ON ON ON ON ON
Tool Number 2 ON ON ON ON ON OFF ON
: : : : : : : ON
Tool Number 11 ON ON OFF ON OFF ON ON
Tool Number 12 ON ON OFF ON OFF OFF ON
: : : : : : : ON
Tool Number 63 OFF OFF OFF OFF OFF ON ON
Tool Number 64 OFF OFF OFF OFF OFF OFF ON
OFF means the contact does not function (Open); ON means the contact functions (Closed).
To Next Page
Loading...
