5-97
Current position is at tool number 1 and tool number 8 is triggered; at this time, it will rotate
forward to tool number 8.
Current position is at tool number 8 and tool number 1 is triggered; at this time, it will rotate
reversely to tool number 1.
Forward/reverse manual continuous tool position mode: Under this mode, there is no need to control
the digital input contact of the tool position. When triggered, it will move N tool positions until the
end is triggered, and it will stay at the next tool position after ended.
Forward/reverse manual continuous mode: Under this mode, there is no need to control the digital
input contact of the tool position; it will start moving after triggered and will move until the end is
triggered. It will remain at any position after the end is triggered.
Tool number selection and the current tool position can be determined using binary decoding
methods of digital input/output signals:
To Next Page
Loading...
