TECO JSDG2S Series - Page 426

7-64
Sn204.0 Zero Speed Determined Operation

【
5-3-7
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 1 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0204H 2204H 2204H O O O O O
Setting Description:
Setting Description
0 Does not operate
1 Treat Speed Command as Zero Speed
Sn205.0 Speed Command Acceleration / Deceleration Method

【
5-3-4
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 3 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0205H 2205H 2205H -- -- -- O --
Setting Description:
Setting Description
0
Do not use Speed Command Acceleration / Deceleration
Function
1
Use the Speed Command One Time Smoothing
Acceleration / Deceleration Function
2
Use the Speed Command Linear Smoothing
Acceleration / Deceleration Function
3
Use S-type Speed Command One Time Smoothing
Acceleration / Deceleration Function