TECO JSDG2S Series - Page 500

7-138
Un-90 Effective load rate
Unit Communication position Parameters description
%
RS-485 CANopen EtherCAT
Effective load rate
0665H 285AH 285AH
Un-91 Color mark distance
Unit Communication position Parameters description
0.1mm
RS-485 CANopen EtherCAT
The travel distance of the spindle corresponding to two DI signals
0666H 285BH 285BH
Un-92 Cut point error
Unit Communication position Parameters description
pulse
RS-485 CANopen EtherCAT
The error value of the spindle when the tool reaches the cut point
0667H 285CH 285CH
Un-93 Slave state
Unit Communication position Parameters description
---
RS-485 CANopen EtherCAT Un-93.0
0: Initialization completed
1: From the axis to the actual zero position, and stop
2: The slave axis starts to run, but it has not yet reached the
synchronization area
3: The slave axis is in the synchronization area
4: The slave axis has passed the synchronization area, but has not
reached the logic zero position
Un-93.1
(DI 0x25 E-STOPIN input)
0: Allow slave axis running
1: The slave axis is not allowed to start a new operating cycle
0668H 285DH 285DH
Un-94 Slave axis angle
Unit Communication position Parameters description
0.01
degree
RS-485 CANopen EtherCAT
Slave axis angle
0669H
066AH
285EH 285EH
Un-95 Lost bid times
Unit Communication position Parameters description
time
RS-485 CANopen EtherCAT
Lost bid times
066BH 285FH 285FH
Un-96 System unit volume position feedback
Unit Communication position Parameters description
unit/PLS
RS-485 CANopen EtherCAT
System unit volume position feedback
066CH
066DH
2860H 2860H