2-29
(f) Analog output interface circuit (
IO6
):
Maximum drive current of analog output is 5mA; please select a measuring device with larger
impedance.
Analog output interface circuit
(g) Absolute position encoder battery interface circuit (
IO7
):
If the battery is already installed in the encoder or on encoder wire, please DO NOT make
this circuit connected.
Battery Specification
• Labeled Capacity: 2400mAh
• Labeled Voltage: 3.6V
• Operating Temperature Range: -40~85ºC
• Maximum Continuous Discharge Current: 100 mA
Absolute position encoder battery interface circuit
v
29 AG
30 MON1
31 MON2
Output ±10V
Max. 5mA
Servo Driver
To Next Page
Loading...
