Installation
For more information on the many probes available for use with DPO4000 oscilloscopes, refer to www.tektronix.com.
Powering On the O scilloscope
Ground the O scilloscope and Yourself
Before pushing the power switch, connect the oscilloscope to an electrically neutral reference point, such as earth gro und. Do this
by plugging the three-pronged power cord into an outlet grounded to earth ground.
Grounding the oscilloscope is ne cessary for safety and to take accurate measurements. The oscilloscope needs to share the
same ground as any circuits that you are testing.
DPO4000 Series User Manual 11
To Next Page
Loading...
Need help?
General
