Analyze Waveform Data
Taking Manual Measurements with Cursors
Cursors are on-screen markers that you position in the waveform display to take manual measurements on acquired data. They
appear as horizontal and/or as vertical lines. To use cursors:
1. Push Cu rsors.
This changes the cursor state. The three
states are:
No cursors appear on the screen,
Two vertical wavef orm cursors appear.
They are attached to the selected
waveform
Four screen cursors ap pear. Two are
vertical and two are horizontal. They
are no longer speci fically attached to
a waveform
For example, the first time you push
Cursors the state might be off.
144 DPO4000 Series User Manual
To Next Page
Loading...
