Acquisition
Changing the Acquisition Mode
Use this procedure to change the a cquisition mode.
1. Select Horiz/Acq > Acquisition Mode.
2. To select an acquisition mode, do one
of the following:
Select an acquisition mode directly
from the m enu.
Click Mode..., and then select an
acquisition mode.
3. For Average or Envelope acquisition
modes, click the #ofWfmscontrol, and
then set t
he number of waveforms with
the multipurpose knob. For WfmDB
mode, click the Samples control, and
then set
the number of samples with the
multipurpose knob.
You can also click the keyboard icon and
use the p
op-up keypad to set the number
of waveforms or samples.
22 TDS6000B & TDS6000C Series Quick Start User Manual
To Next Page
Loading...
