tell Adapter2 - Page 71

71
3G network usage is supported by the 3G(A).IN4.R1 and the 4G(A).IN4.R1 model of the
Adapter2 only! LTE network usage is supported by the 4G(A).IN4.R1 model only!
Use automatic selection upon network errors: if this option is enabled, the device will select an
available network when service error occurs, even if the use of a specific network is selected in
the settings (2G, 3G, or LTE).
VoLTE support (4G model only): if you enable this option, the device will try to connect to the
VoLTE service through which it can make and receive LTE-based calls. This requires mobile
Internet and VoLTE service enabled on the SIM card installed in the device, and configured APN
settings in the device settings. Do not enable this option if any of the above is not available,
otherwise the network connection may fail.
Manual dialing:
If you are using the device with a telephone handset, for manual dialing of telephone numbers you
can configure the time the device should wait after each entered digit, before it starts dialing the
number. You can set the time separately for the first 4 digits, and from the 5th digit up to the end
of the number.
Dialing timeout for the first 4 digits: in this section you can set the time the device waits after
each digit before it starts dialing the entered number, when you enter the first 4 digits of the
number.
Dialing timeout from the 5th digit: in this section you can set the time the device waits after
each digit before it starts dialing the entered number, when you enter the 5th and next digits of the
number.
Locking the device:
Status: you can lock your device with this setting, so that the factory default settings cannot be
restored without knowing the device password.
• Unlocked: when unlocked, the factory default settings can be restored anytime, also
without knowing the device password.
• Locked: when locked, restoring the factory default settings is disabled. You can restore the
factory default settings only after logging in with the Superadmin or Admin password and
changing the setting to unlocked. If you forget these passwords, only the manufacturer can
restore the factory default settings in the service center.