Tenda W15E User Manual

106
The entry shown in the following figure appears.
Step 2 Set Router 2.
1. Click +Add.
2. Set the rule.
(1) IPSec: Click Enable.
(2) WAN: Select the WAN port used by the tunnel, which is WAN1 in this example.
(3) Connection Name: Set the name of the tunnel, which is IPSec_1 in this example.
(4) Remote Gateway (Domain Name): Enter the WAN IP address used by the peer IPSec tunnel, which

Tenda W15E Specifications

General

Brand	Tenda
Model	W15E
Category	Network Router
Language	English