31
(2) Subnet mask: Enter the subnet mask of the destination IP address, which is 255.255.0.0 in this
example.
(3) Gateway: Enter the gateway of WAN2 port of the router, which is 192.168.58.1 in this example.
(4) Interface: Select the port for the destination network, which is WAN2 in this example.
(5) Click OK.
---End
After configuring, the newly added static route rule appears in the route table.
Verification
Verify that clients on the LAN network can access the internet and the intranet.
5.6 Any IP
By default, the clients connected to the router can access the internet either by automatically obtaining the IP
address, or with a manually configured IP address, gateway and DNS.
The router supports internet connection of clients configured with any IP address. After the Any IP function is
enabled, users can access the internet without modifying the original configuration of their clients.
After the Any IP function is enabled, the client can access the internet by automatically obtaining the IP
address, or manually being configured with correct IP address, gateway and DNS.
To Next Page
Loading...
