110
Step 2 To enable this function, select the Enable check box of IP-MAC Binding, and click OK.
Step 3 Click +Add to manually set the IP-MAC binding rule; or you can add the binding rule in Dynamic Binding
module.
---End
10.1.3 Example of IP-MAC Binding
Networking requirement
A company uses W15E to deploy a network. The company stipulates that only recruitment employees can access
the internet using the specified computer and IP address.
Solution
The IP-MAC Binding function is recommended to address the requirement. Assume that the IP addresses and its
corresponding MAC addresses of the computers that can be used by recruitment employees to access the internet
are 192.168.0.11, C8:3A:35:13:05:18 and 192.168.0.12, C8:3A:35:D5:75:A6.
Configuration procedure
Step 1 Choose Security > IP-MAC Binding.
Step 2 To enable this function, select the Enable check box of IP-MAC Binding, and click OK.
To Next Page
Loading...
