80
Verification
Verify that computers on LAN network belonging to IP group of 192.168.0.2~192.168.0.250 cannot access the
selected websites.
7.6 Multi-WAN Policy
7.6.1 Overview
This module enables you to set the WAN port policy of the router. You can enable this function when multiple
WAN ports are used.
The WAN ports of the router support two modes: Smart Load Balancing and Custom Policy. To access the page,
choose Filter Management > Multi-WAN Policy.
Parameter description
It specifies the policy on the WAN ports of the router.
Smart Load Balancing: The system automatically uses the WAN port with the lightest
traffic to communicate.
Custom Policy: It allows users to specify the corresponding WAN port for a certain
source address as required.
After this function is enabled, the router regularly detects the communication status
between the WAN port and the detection address.
Detection Address: It specifies the IP address or domain name to be detected.
Detection Interval: It specifies the interval of detection. The default interval is 5 minutes
and the upper limit of the interval is 200 minutes.
7.6.2 Custom Policy Rule
Step 1 To access the page, choose Filter Management > Multi-WAN Policy.
Step 2 Click the check box of Custom Policy, and click OK.
Step 3 Click +Add.
To Next Page
Loading...
Need help?
General
