Tenda W15E - Page 92

81
Step 4 Set the multi-WAN policy parameters.
---End
Parameter description
Parameter
Description
It is used to add the multi-WAN policy rule.
It is used to delete the selected rule.
IP Group
It specifies the IP Group to which the rule is applied.
Specified WAN
It specifies the WAN port of ingoing and out going packet of a IP group.
Status
It specifies the current status of the rule, including Enabled and Disabled.
Operation
The following operations can be preformed on the rules:

: It is used to disable the rule.

: It is used to enable the rule.

: It is used to edit the rule.

: It is used to delete the rule.