17
---End
Wait a second. You can access the internet when the connection status is Connected.
5.1.3 Static IP
If your ISP provides a fixed IP address, you can choose Static IP as the connection type. The following describes
the configuration steps.
Step 1 Choose Network > Internet Setup. The page displays the parameters for the function.
Step 2 Connection Type: Select Static IP.
Step 3 IP Address, Subnet Mask, Gateway, Primary/Secondary DNS: Enter the relevant values provided by your
ISP.
Step 4 Click OK.
---End
Wait a second. You can access the internet when the connection status is Connected.
5.2 WAN Parameters
5.2.1 Overview
This section enables you to modify the WAN parameters in case that you cannot access the internet after
configuring the internet settings. To access the page, choose Network > WAN Parameters.
To Next Page
Loading...
