85
Step 2 Select Manual bandwidth control from the drop-down list box of Control Mode.
Step 3 Set the control rule in the window that appears.
Step 4 Click OK.
---End
Parameter description
It is used to add client bandwidth control rules.
It is used to delete the selected rule.
It specifies the IP group covered by the enabled bandwidth control rule.
It specifies the time group covered by the enabled bandwidth control rule.
Concurrent
Sessions Per
Device
It specifies the maximum number of connections that can be set up on each computer
covered by the corresponding rule.
It specifies the mode of the bandwidth control rule.
Shared: It indicates that the total bandwidth of all IP addresses covered by a rule equals
to the upload/download rate set in the rule.
Exclusive: It indicates that the bandwidth of every IP address covered by a rule is the
upload/down rate set by the rule.
It specifies the device’s maximum upload/download rate covered by the corresponding
rule.1 Mbps=128 KB/s=1024 kb/s
To Next Page
Loading...
Need help?
General
