Tonghui TH2816B - Page 73

73
:TOLerance:BIN<n>
The :TOLerance:BIN<n> command sets the low/high limit values of each BIN for the
comparator function tolerance mode. These limits can be set only when the limit
mode is set to the tolerance mode. The :TOLerance:BIN<n>? query returns the
current settings of the low/high limit values of each of the BINs.
Command Syntax
COMParator:TOLerance:BIN<n> <low limit>,<high limit>
Where,
<n> 1 to 4 (NR1) : BIN number
<low limit> NR1, NR2, or NR3 format with suffix ma, k, m, u, n, p.
<high limit> NR1, NR2, or NR3 format with suffix ma, k, m, u, n, p.
Note The low limit value should be lower than the high limit value. If the low limit
value is set higher than the high limit, a warning message is displayed when
this command is received (an error does not occur).
Example
WrtCmd(“COMP:TOL:BIN1 -5,5”)
WrtCmd(“COMP:TOL:BIN2 -10,10”)
Query Syntax
COMParator:TOLerance:BIN<n>?
Query Resopnse
Returned Format is:
<low limit>,<high limit><NL^END>
Low limit and high limit are NR3 format. If the current limits are not set, “9.9E37,
9.9E37” will be returned.
:Secondary LIMit
The :Secondary LIMit command sets the low/high limit values for the comparator
function secondary parameter. The :Secondary LIMit? query returns the current
settings of the secondary parameter low/high limit values.
Command Syntax
COMParator:SLIMit <low limit>,<high limit>
Where,
<low limit> is the NR1, NR2, or NR3 format with suffix ma, k, m, u, n, p.
<high limit> is the NR1, NR2, or NR3 format with suffix ma, k, m, u, n, p.
Note: The low limit value should be lower than the high limit value. If the low limit
value is set higher than the high limit, a warning message is displayed when
this command is received (an error does not occur).
Example
WrtCmd(“COMP:SLIM 0.001,0.002”)
Query Syntax
COMParator:SLIMit?
Query Response
Returned Format is: