18. OUTPUTTING DATA
94
10. Enter a filename and press [OK].
11. Output starts.
• Do not remove the SD card or turn off the DL
while files are being copied/transferred.
12. Press {ESC} to return when "Completion" is
displayed.
PROCEDURE Outputting route data to a USB memory device
1. Open the external interface hatch cover.
2. Insert a USB memory device into the USB
port.
3. Select “JOB” in <Management menu>.
4. Select “Comms output”.
5. Select format from "CSV 1", "CSV 2" or
"SDR2X".
6. Check that "Com. locat." is set to "USB.
7. Repeat steps 7 to 12 in “PROCEDURE
Outputting route data to an SD card”
•Do not disconnect the USB memory or turn off the DL while files are being copied/transferred.
DL-501_E.book 94 ページ ２０１５年９月１７日 木曜日 午後１時２１分
To Next Page
Loading...
