Topcon GTS-601 - Resume Mode ON;OFF; How to Enter Numerals and Alphabet Letters

2-8
2 PREPARATION FOR MEASUREMENT
2.8 Resume Mode ON/OFF
(Memorizing the measurement mode when power is off.)
The Resume Mode will memorize the last display or mode when the power is turned OFF. When the
power is turned back ON, the last display or mode will be shown . This option saves time and
keystrokes in the field.
Note:
If [F2](ON) key is selected, the instrument must be leveled before power is ON. If it is not leveled, the tilt
over display will appear. In this case, rotate the leveling screw and level the instrument.
2.9 How to Enter Numerals and Alphabet Letters
This enables you to enter numerals or alphabet letters such as the file name.
[Example] Enter “HIL
104” to rename the file name.
Operating procedure Option Display
1 Press [F1](Alpha) key to be entering alphabet
letter mode.
[F1]
2 Enter Alphabets. *1)
Input “H”
Move cursor
Input “I”
Input “L”
Input “
”
[9][9]
[F4]
[9][9][9]
[4][4][4]
[3][3][3]
3 Press [F1](Num) key to be entering numeric
mode.
Input “104”
[F1]
[1][0][4]
4 Press [ENT] key.
[ENT]
*1)When entering a alphabet in the same key consecutively, press [F4](→) key to move the cursor to the
right then enter the alphabet key.
Pressing [F1](OFF) key or [F2](ON) key, select the resume mode.
[F1] [F2]
Power off
Resume mode
OFF ON ESC
Power switch key OFF
Rename
Old name [TOPCON .DAT]
New name [
]
Alpha SPC ← →
Rename
Old name [TOPCON .DAT]
New name [HIL
]
Num SPC ← →
Rename
Old name [TOPCON .DAT]
New name [HIL
104 ]
Alpha SPC ← →