Topcon HiPer+ - Page 120

Troubleshooting
HiPer+ Operator’s Manual
6-6
1. Connect your receiver and a computer and start
PC-CDU. See “Connecting the Receiver and a
Computer” on page 2-14.
2. Click ConfigurationAdvanced and the Multipath
Reduction tab. Enable the two boxes and click Apply.
• Move to an area free of obstructions, if applicable.
The receiver cannot obtain Code Differential and/or RTK
solutions.
D Incorrect Base coordinates entered.
Specify the correct coordinates for the Base station using
PC-CDU or another suitable field data collection software.
D The receiver is not configured as a Base or Rover.
• If the receiver should FN as a Base, ensure it has the proper
configuration. See Chapter 3 for details.
• If the receiver should FN as a Rover, ensure it has the
proper configuration. See Chapter 3 for details.
D The corresponding receiver options may be disabled or expired.
• See “Managing Receiver Options” on page 5-6 for details
on how to check current options.
• Order a new OAF with the desired options activated to
enable or extend validity of the corresponding receiver
options. Contact your dealer or visit the TPS website for
details
• Refer to the PC-CDU Reference Manual for a detailed
description of options.
D There are not enough common satellites. In order to obtain a
fixed solution, the Base and Rover should track at least five
common satellites.
• Ensure that both the Rover and Base receivers use the
same, and updated, almanac. See “Collecting Almanacs
and Ephemerides” on page 2-21.