Receiver Problems
P/N 7010-0526
6-5
Generic problems:
D The receiver port used for connection is not in Command mode.
1. Connect your receiver and a computer using a free port
(see “Connecting the Receiver and a Computer” on
page 2-14) and start PC-CDU.
2. Click ConfigurationReceiverPorts.
3. Change the Input for the port used for connection to
“Command”.
The receiver does not lock on to satellites for a long period of
time.
D The receiver stores an old almanac.
Update the almanac. See “Collecting Almanacs and
Ephemerides” on page 2-21 for details.
D The corresponding receiver options may be disabled or expired
(L1/L2, GPS/GLONASS must be on to track satellites).
• See “Managing Receiver Options” on page 5-6 for details
on how to check current options.
• Order a new OAF with the desired options activated to
enable or extend validity of the corresponding receiver
options. Contact your dealer or visit the TPS website for
details
• Refer to the PC-CDU Reference Manual for a detailed
description of options.
The receiver tracks too few satellites.
D The elevation mask value is too high (above 15 degrees).
Lower the elevation mask. See page 3-19 for information on
setting the elevation mask.
D The survey is conducted near obstructions (tree canopy, tall
buildings, etc.).
• Check that the Multipath Reduction boxes have been
enabled using the following steps.
To Next Page
Loading...
