Topcon HiPer+ - Page 125

Bluetooth Problems
P/N 7010-0526
6-11
D The receiver port used for connection is not in Command mode.
1. Connect your receiver and a computer using a free port
(see “Connecting the Receiver and a Computer” on
page 2-14) and start PC-CDU.
2. Click ConfigurationReceiverPorts.
3. Change the Input for the serial port used for connection
to “Command”.
D The settings for Port B may have been changed.
• The settings for Port B are: 115200 baud rate, 8 data bits, 1
stop bit, no parity, and no handshaking.
• Try enabling RTS/CTS handshaking for Port B. Do not
change other settings.
D The corresponding receiver options may be disabled or expired.
• See “Managing Receiver Options” on page 5-6 for details
on how to check current options.
• Order a new OAF with the desired options activated to
enable or extend validity of the corresponding receiver
options. Contact your dealer or visit the TPS website for
details
• Refer to the PC-CDU Reference Manual for a detailed
description of options.
BTCONF error message: Can’t find Bluetooth.
D The receiver’s Slot 3 is turned off.
1. See “Establishing an RS232 Cable Connection” on
page 2-15 to connect the computer and receiver.
2. Click ConfigurationReceiverGeneral.
3. In the Turn on/off Slots area, enable the Slot 4 (D) check
box.
D The Bluetooth module is linked with another device.
Close the connection with the device, then connect to your
receiver.