Topcon HiPer+ - Page 136

Creating Scripts
HiPer+ Operator’s Manual
B-2
8. Type in the desired commands, clicking Enter after each one. See
Table B-1 for Daisy Chain commands.
9. Click Save script.
10. Click Close editor.
Once you have created a script file, load it with a few quick clicks.
1. Click Load script on the Manual Mode dialog box.
2. Navigate to the folder that contains your script file.
3. Select the appropriate script file and click Open.
4. Press Enter or click Send command to run the script file.
Table B-1. Script Commands
To Create Daisy Chain To End Daisy Chain
%%set,dev/ser/c/rate,38400
%%set,dev/ser/c/echo,/cur/term
%%set,dev/ser/c/imode,echo
%%set,cur/term/eoff,QUIT
%%set,cur/term/echo,/dev/null
%%set,cur/term/imode,echo
%%set,cur/term/echo,/dev/ser/c
QUIT
%%set,cur/term/imode,cmd
%%set,dev/ser/c/echo,/dev/null
%%set,dev/ser/c/imode,cmd
%%set,dev/ser/c/rate,38400
%%set,cur/term/rate,115200